This one may seem a bit like a very involved configuration but in reality is not. The process is easy, if you know how to set up AnyConnect in an ASA, you will be able to crack it.
I have also included few links that show the process and the important things that you need to consider, as well as licensing requirements
Useful Links: ASA Sample Configuration: (http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/security/8_5_1/secugd/sec-851-cm/secuvpn.html#wp1054676)
Configure AnyConnect VPN IP Phones with Certificate Authentication on an ASA (http://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications-manager-callmanager/115785-anyconnect-vpn-00.html)
Yes, another upgrade and more with it. This one was very special and I was totally blaming myself after the TAC engineer helped me figure it out.
I was always told, or I remember it was good practice to always get the latest Upgrade file from CCO Downloads page for everything. Well I did that and found myself into an issue.
The scenario:
Customer Upgrading CUCM, CUC and IM&P servers from 9.1.2 to Version 10.5 (No issue here):
So with the introduction of Cisco Prime Collaboration Deployment, now upgrade any of your UC applications its easier and quicker than before. One of the big advantages that I see with this new product is that the product can have control of the overall infrastructure, starting from VMware all the way to the UC applications.
For a better understanding of this product you can use the following link: (http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/pcdadmin/10_0_1/CUCM_BK_U9C58CB1_00_pcd-administration-guide-1001.html) - The previous is the one for version 10.x – I don’t see too many changes from version to version.
Hi there, today I have a customer that wanted to upgrade from CUCM 9.1.2 to 10.5 - which sounds pretty easy… think again, so this is a BE6K deployment where CUCM instance was configured with the recommended OVA from CCO. When starting the upgrade I found that the upgrade didn’t wanted to proceed as expected. and I was getting the following error:
Installation of UCSInstall_UCOS_10.5.1.10000-7.sgn.iso failed
An error has occured but no messages are available. This can happen when another administrator is working on the system at the same time and triggers an error.
